Remove it with a flat screwdriver. Turn the machine power off. Remove the bushing [A] of the development roller at the rear of the PCU 6. Open the drum positioning plate [D]. Remove the front joint [A] The front joint [D] is firmly set.

Uploader: Daikora
Date Added: 25 November 2014
File Size: 49.30 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 70564
Price: Free* [*Free Regsitration Required]

Savin C – Toner Cartridges (Black, Cyan, Magenta, Yellow)

Entering SP Mode 1. Remove the front joint [A] The front joint [D] is firmly set. Turn the machine power sqvin. Leave a Reply Cancel reply You must be c282 in to post a comment. Execute the drum phase adjustment with SP twice. Open the drum positioning plate [D]. Turn the machine power on.

Reattach the hopper cover hook x 3. Majority of print quality problems are related to parts of the drum unit. Typically once you begin experiencing color streaks or color back grounding it can be a symptom that the charge grid and cleaning blade are beginning to go bad.

TOP Related Posts  BROTHER P TOUCH 2420PC DRIVER

Do not touch the OPC drum. The hook breaks easily. When reassembling the PCU: Keep the developer off at both ends of the development unit enclosed in red lines in the diagram.

Rotate the development roller [A] five or six times in the counterclockwise direction. The new drum unit has a front cover and a front joint. Drum unit [A] and Development Unit [B] 8. The steps below included directions for both replacement procedures. The bearing is properly applied with lubricant. Do the ACC procedure. Open the front door. Shake a bag of developer and pour it into the development hopper [A].

Savin C2828 Toner Cartridges – MP C2800, MP C3300 Cartridges

If you change the development unit, do the ACC procedure. Follow the correct order.

Hopper cover [A] 4 hooks Release the three hooks first in the correct order Put the head of a screwdriver in the groove gap [B] as shown, and then release the hook. Remove the bushing [A] of the development roller at the rear of the PCU 6.

TOP Related Posts  EMACHINES T3065 DRIVERS DOWNLOAD

Product Center

You must be logged in to post a comment. When you attach the new drum unit to the development unit, remove a front cover asvin a front joint at first and use them for reassembling the new drum unit and development unit. Pull out the PCU hold the grip while you pull it out.

Enter the Service Mode. The machine initializes the developer and eavin the PM counter for the developer. Turn the drum positioning plate lever [B] and the image transfer unit lock lever [C] counter-clockwise. Lever lock [A] 3. Make sure that the harness [A] is hooked as shown.

Otherwise, the hopper cover may be damaged.